When
we want to change ourselves Without a garage. If you
install it. Removing is not difficult.
Input
Conditions
Required
Conditions : Battery safe for maintenance, New Water Pump and Gasket.
Personnel
Recommended : Two
Support
Equipment :
1.
Standard Length Open End Wrench ; 10, 12, 14 mm.
2.
Angle Head Box Spline Wrench ; 12, 14, 17 mm.
3.
Socket ; 10, 12, 14, 17, 19 mm.
4.
Ratchet + Adapter + Locking Button
Extension ; 6 inch 2 each.
5.
Adj. Click Type Torque Wrench ; 168 inch-pounds and 1,212 inch-pounds.
6.
Flat Tip Screwdriver, Flat-nose pliers, Pick-up Tool, Rubber Head Mallet
7.
Sealling silicone, Wire brush, Toothbrush, Sandpaper, Engine Cleaner, Scissors,
Straps, Flashlight and Cheesecloth.
Procedures
1.
Clean the area to install.
-
Injected with Engine Cleaner and Using wire brush, toothbrush, sandpaper, flat
screwdriver
-
Wipe clean with a Cheesecloth.
Note ;
Be careful not to hit the Timing belt.
2.
Installation the new water pump and Timing belt tension spring.
-
Apply silicone to the new pump and mounting space.
-
Put the gasket at the new pump.
-
Installed with 6 mounting bolts and Torque 168 inch-pounds
-
Install the Timing Tension Spring with Timing belt hock using a flat
screwdriver.
-
Install the belt cover with the 11 mounting bolts using the Socket 10 mm.
4.
Install Crankshaft Pulley.
-
Align the pulley set key with the key groove of the pulley.
-
Using a mallet, drive in the pulley.
-
Using the socket 19 mm. and torque 1,212 inch-pounds
5.
Install 4 Drive Belts.
5.1
Put A-belt (Size 12.5*835) between the Crankshaft pulley and the Power Steering
Pulley then adjust tension of A-belt.
5.2
Put 2 B-belts (Size 12.5*1050) between the Crankshaft pulley and the Alternator Pulley
and the Water Pump Pulley then adjust tension of 2 B-belts.
5.3
Put C-belt between the Crankshaft pulley and
the Air Comp. Pulley and the Adjuster Pulley then adjust tension of C-belt.
6.
Put a car radiator and radiator cover and fan simultaneously.
-
Install the fan with the four nuts.